Idaho Transportation Department

Travel Services

News and Information

Printer-Friendly Version

ITD Home

News and Info

Contact Us

Bridge Home LRFD Bridge Design Manual CHAPTER 0. POLICY AND PROCEDURES CHAPTER 1. INTRODUCTION CHAPTER 2. GENERAL DESIGN AND LOCATION FEATURES CHAPTER 3. LOADS AND LOAD FACTORS CHAPTER 4. STRUCTURAL ANALYSIS AND EVALUATION CHAPTER 5. CONCRETE STRUCTURES CHAPTER 6. STEEL STRUCTURES CHAPTER 7. ALUMINUM STRUCTURES CHAPTER 8. WOOD STRUCTURES CHAPTER 9. DECKS AND DECK SYSTEM CHAPTER 10. FOUNDATIONS CHAPTER 11. ABUTMENTS PIERS AND WALLS CHAPTER 12. BURIED STRUCTURES AND TUNNEL LINERS CHAPTER 13. RAILINGS CHAPTER 14. JOINTS AND BEARINGS CHAPTER 15. CONSTRUCTION CHAPTER 16. COST ESTIMATING CHAPTER 17. PLANS

CHAPTER 14. JOINTS AND BEARINGS

14.5 Bridge Joints
14.7.2 TFE/Stainless Steel Expansion Bearing Units
14.7.5 & 7.6 Design Guidelines for Elastomeric Bearings

Appendix A – Design Aids

A14.2 Compressive Strain Curves
A14.3 Cotton Duck Reinforced Pad
A14.4 Bearing Tabulation Table
A14.5 TFE/SS Expansion Bearing Design Procedure
A14.6 Bridge Joint Selection Criteria/Design Examples

Appendix B – Standard Drawings

B14.0 Standard Drawing Revision Log (pdf)
B14.1A Compression Seal Joints – skew < 10º
B14.1B Compression Seal Joints – skew < 30º
B14.2 Strip Seal Joints
B14.3 Modular Joints
B14.4 Parapet Cover Plates
B14.5 Silicone Sealant Joint
B14.6 Asphaltic Plug Expansion Joint
B14.7A Stainless Steel/TFE Bearing – Steel Girder
B14.7B Stainless Steel/TFE Bearing – Concrete Girder

Page Last Modified: 8/19/2009 1:29:42 PM

About Us | Traveler Services | DMV | Projects | News And Info | Reader-Friendly
Idaho Transportation Department
3311 W. State Street · P.O. Box 7129
Boise, ID 83707-1129